Product Overview
This trigger set includes a modified Glock performance trigger with OEM Flat, OEM curved, or aluminum trigger shoe with over travel adjustment screw and reduced pretravel (no pretravel reduction also available upon request), reduced power firing pin safety spring, OEM standard or our minus connector, and gen 5 backplate.
The Glock Performance trigger design allows for lighter pull weights than our traditional glock trigger setups. This trigger has an angled sear which makes it easier to push through the wall when staging the trigger quickly even at higher pull weights. For this reason, shooters looking for the most predictable wall and break may prefer our traditional glock trigger offerings.
The set comes in a drop-in configuration ready for your gunsmith to install. Installation and safety checks are provided with the kit. Typical installation is 5 to 10 minutes. Check out the installation video below to get an idea of what to expect. To help with installation and safety checks, we also recommend purchasing our Armorer's Kit for Glocks (select the gen 1-5 compatible armorer's plate).
Pull weight for this kit is 3.5 pounds (standard connector) or 2.5 pounds (minus connector) as measured at the bottom of the trigger shoe and should be within half a pound. This setup can be configured heavier (half to a full pound) by using your OEM safety plunger spring instead of the provided reduced power plunger spring.
In stock but orders placed from 3/29/25 to 4/3/25 will ship starting 4/4/25 as we are away from the shop.
Notes: The 9mm options listed exclude Glock 43/43x/48 (see listing here for Glock 43/43x/48). Order 9mm/gen 5 for 19x, 45, and 47 models. Is also compatible with most gen 3/4 clones as well.
Disclaimer: This kit should be installed by a certified and knowledgeable gunsmith. Due to tolerance variations between guns, safety and reliability margins should be inspected during installation and periodically thereafter during maintenance. Proper trigger safety function should be verified after installation. Engagement of the sear to firing pin should be inspected to verify sufficient coverage of the interfacing surfaces. Tactical Trigger, LLC assumes no liability for installation or use of this product.
DISCLAIMER: This product is not manufactured, authorized, endorsed,
or warranted by GLOCK. GLOCK does not warrant or represent that
this product is compatible with GLOCK pistols.
DISCLAIMER: “GLOCK” is a federally registered trademark of GLOCK,
Inc. and is one of many trademarks registered by GLOCK, Inc. and GLOCK
Ges.m.b.H. Neither Tactical Trigger, LLC, nor this site are affiliated in any
manner with, or otherwise endorsed by, GLOCK, Inc. or GLOCK
Ges.m.b.H. The use of “GLOCK” on this page is merely to advertise the
sale of products compatible with GLOCK pistols, parts, or components. For
genuine GLOCK, Inc. and GLOCK Ges.m.b.H products and parts visit
www.glock.com.
