Product Overview
This kit includes an aluminum flat faced trigger shoe or polymer trigger shoe (modified OEM trigger shoe with reduced pretravel, optional finger relief/flush fit safety modification) with an over travel adjustment screw, a tuned OEM trigger bar, polished safety plunger, and reduced power safety plunger spring. Installation and safety checks are provided with the kit.
The set comes ready for your gunsmith to install. Installation and safety checks are provided with the kit. Typical installation is 5 to 10 minutes. Check out the install and safety check page to get an idea of what to expect.
The Glock 43/43x/48 design doesn't support an enhanced minus connector/grail pin but this setup has equivalent performance to our larger Glock triggers. To keep a crisp wall, it is recommeded to use the factory minus connector that comes with your gun. Pull weight with this kit is 3.5 to 4 lbs using the OEM minus connector. For a 4.5# pull use the OEM safety plunger spring. Pull weight specified is as measured at the bottom of the trigger shoe and should be within half a pound. The polymer and flat indexed trigger shoes tend to feel heavier based on the finger position being higher.
In stock and ships in 3 to 5 business days.
DISCLAIMER: This product is not manufactured, authorized, endorsed,
or warranted by GLOCK. GLOCK does not warrant or represent that
this product is compatible with GLOCK pistols.
DISCLAIMER: “GLOCK” is a federally registered trademark of GLOCK,
Inc. and is one of many trademarks registered by GLOCK, Inc. and GLOCK
Ges.m.b.H. Neither Tactical Trigger, LLC, nor this site are affiliated in any
manner with, or otherwise endorsed by, GLOCK, Inc. or GLOCK
Ges.m.b.H. The use of “GLOCK” on this page is merely to advertise the
sale of products compatible with GLOCK pistols, parts, or components. For
genuine GLOCK, Inc. and GLOCK Ges.m.b.H products and parts visit
www.glock.com.
