Product Overview
This part replaces the stock connector and includes our patent pending trigger bar alignment tab to eliminate stacking into the wall. This connector is pre-adjusted for tension and trigger bar alignment. Additional adjustment is usually not necessary but can be performed if needed for the unique tolerances of the gun and the parts being used. Compatible with all models (17, 19, 20, 21, 22, 23, 34, 19x, 44, 45, etc) except for single stack models (42, 43, 43x, 48).
In stock and ships in 1 to 2 business days.
Disclaimer: This part should be installed by a certified and knowledgeable gunsmith. Due to tolerance variations between guns, safety and reliability margins should be inspected during installation and periodically thereafter during maintenance. Proper trigger safety function should be verified after installation. Engagement of the trigger bar to firing pin should be inspected to verify greater than 2/3 coverage of the trigger bar interfacing surface. Although it is unlikely that installation of this part will result in inadequate margins, a parts configuration should be used or adjustments should be performed to achieve necessary margins. Tactical Trigger, LLC assumes no liability for installation or use of this product.
DISCLAIMER: This product is not manufactured, authorized, endorsed,
or warranted by GLOCK. GLOCK does not warrant or represent that
this product is compatible with GLOCK pistols.
DISCLAIMER: “GLOCK” is a federally registered trademark of GLOCK,
Inc. and is one of many trademarks registered by GLOCK, Inc. and GLOCK
Ges.m.b.H. Neither Tactical Trigger, LLC, nor this site are affiliated in any
manner with, or otherwise endorsed by, GLOCK, Inc. or GLOCK
Ges.m.b.H. The use of “GLOCK” on this page is merely to advertise the
sale of products compatible with GLOCK pistols, parts, or components. For
genuine GLOCK, Inc. and GLOCK Ges.m.b.H products and parts visit
www.glock.com.
