This kit includes an aluminum trigger shoe (flat, flat indexed, or large flat) or polymer trigger shoe (modified OEM trigger shoe with reduced pretravel, optional finger relief/flush fit safety modification) with an over travel adjustment screw, a tuned OEM trigger bar, polished safety plunger, and reduced power safety plunger spring. Installation and safety checks are provided with the kit.
The set comes ready for your gunsmith to install. Installation and safety checks are provided with the kit. Typical installation is 5 to 10 minutes. Check out the install and safety check page to get an idea of what to expect.
The Glock 43/43x/48 design doesn't support a grail pin but this setup now has equivalent performance to our larger Glock triggers with grail pins. To keep a crisp wall, it is recommeded to use the factory minus connector that comes with your gun. Pull weight with this kit is 3.5 to 4 lbs using the OEM minus connector. For a 4.5# pull use the OEM safety plunger spring. Pull weight specified is as measured at the bottom of the trigger shoe and should be within half a pound. The polymer and flat indexed trigger shoes tend to feel heavier based on the finger position being higher.
Due to lack of Glock OEM parts availability (trigger bar and safety plunger), we have provided an option to use your parts for a new order in the drop-downs above. We are able to keep everything else needed in stock and current turn around time is 1-2 days when sending in parts (OEM trigger bar and safety plunger). When using this option, print out your order confirmation or send in a note to use your parts against an existing order.
Send your parts to:
665 South 100 East
Mantua, UT 84324